Low Battery Warning - DeWalt DCD200 Guide D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

English

2. For long storage, it is recommended to store a fully

charged battery pack in a cool dry place out of the

charger for optimal results.

nOTE: Battery packs should not be stored completely

depleted of charge. The battery pack will need to be

recharged before use.

SAVE THESE INSTRUCTIONS FOR

FUTURE USE

COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part

of it. Damage or personal injury could result.

Refer to Figure A at the beginning of this manual for a

complete list of components.

INTENDED USE

This drain snake is designed for professional drain

cleaning applications.

DO nOT use under excessively wet conditions or in

presence of flammable liquids or gases.

This drain snake is a professional power tool. DO nOT let

children come into contact with the tool. Supervision is

required when inexperienced operators use this tool.

Variable Speed Trigger Switch (Fig. A)

To turn the tool on, squeeze the trigger switch

the tool off, release the trigger switch. The tool speed is

controlled by varying the trigger position.

nOTE: Continuous use in variable speed range is not

recommended. It may damage the switch and should

be avoided.

Forward/Reverse Control Button (Fig. A)

A forward/reverse control button

direction of the cable and also serves as a lock-off button.

To select forward rotation, release the trigger switch and

depress the forward/reverse control button on the right side

of the tool.

To select reverse, release the trigger switch and depress the

forward/reverse control button on the left side of the tool.

The center position of the control button locks the tool in

the off position. When changing the position of the control

button, be sure the trigger is released.

nOTE: The first time the tool is run after changing the

direction of rotation, you may hear a click on start up. This is

normal and does not indicate a problem.

nOTE: The tool must come to a complete stop before

changing the tool's direction or running the tool in the

opposite direction.

Front Handle/Cable Lock (Fig. A)

The front handle

has a lock position and unlock

position. When pulled forward, the front handle will unlock

allowing the cable to be pulled out of or pushed into the

drum. When pulled backward, the front handle locks the

cable into position.

. To turn

determines the spin

Adjustable LED Worklight (Fig. A, D)

The adjustable LED worklight

base of the fixed drum shield

is located on the foot of the tool's main handle

worklight is activated when the trigger switch is depressed.

The low, medium and spotlight modes can be changed

by moving the switch

. If the trigger switch remains

depressed, the worklight will remain on in all modes.

In low and medium settings, the beam will automatically

turn off 20 seconds after the trigger switch is released.

Fig. D

Spotlight Mode

The high setting is the spotlight mode. The spotlight will

run for 20 minutes after the trigger switch is released. Two

minutes before the spotlight will shut off, it will flash twice

and then dim. To avoid the spotlight shutting off, lightly tap

the trigger switch.

WARNING: While using the worklight in medium

or spotlight mode, do not stare at the light or

place the tool in a position which may cause

anyone to stare into the light. Serious eye injury

could result.

CAUTION: When using the tool as a spotlight, be sure

it is secured on a stable surface where it will not cause

a tripping or falling hazard.

CAUTION: Fully retract the cable into the drum

before using the tool as a spotlight. Personal injury or

property damage could result.