Winding The Bobbin - Janome 49018 Manuel D'instructions

• Winding the bobbin

NOTE:
Set the speed control lever at its fastest position for
bobbin winding.
z Draw the thread from the spool.
x Guide the thread around the thread guide.
c Pass the thread through the hole in the bobbin from the
inside to the outside. Put the bobbin on the bobbin
winder spindle.
v Push the bobbin winder spindle to the right.
The bobbin sign q appears on the LCD display.
b Hold the free end of the thread in your hand and start
the machine.
Stop the machine when the bobbin has been wound a
few layers, and cut the thread close to the bobbin.
n Start the machine again. When the bobbin is fully
wound, it will stop automatically.
Stop the machine and return the bobbin winder spindle
to its original position by moving it to the left, and cut
the thread with a pair of scissors. Remove the bobbin
from the bobbin winder spindle.
NOTES:
• The machine will not sew until the spindle has been
returned to the left.
• For safety purposes, the machine will stop automatically
2 minutes after the start of bobbin winding
x
x
c
v
b
n
26
c
z
q