Electromagnetic Compatibility Information - Beurer IH 40 Manuel D'utilisation

Electromagnetic Compatibility Information

Table 1
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration – electromagnetic emissions
The IH 40 is intended for use in the electromagnetic environment specified below. The customer or the user of the IH 40 should assure
that it is used in such an environment.
Emissions
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/flicker emissions
IEC 61000-3-3
Table 2
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration – electromagnetic immunity
The IH 40 is intended for use in the electromagnetic environment specified below. The customer or the user of the IH 40 should assure
that it is used in such an environment.
Immunity test
Electrostatic discharge (ESD)
IEC 61000-4-2
Electrical fast transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short interrup-
tions and voltage variations
on power supply input lines
IEC 61000-4-11
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE: U is the a.c. mains voltage prior to application of the test level.
T
Compliance Electromagnetic environment – guidance
Group 1 The IH 40 uses RF energy only for its internal function. Therefore, its RF emissi-
ons are very low and are not likely to cause any interference in nearby electronic
equipment.
Class B The IH 40 is suitable for use in all establishments, including domestic establish-
ments and those directly connected to the public low-voltage power supply net-
Class A
work that supplies buildings used for domestic purposes.
Complies
EN 60601 test level
± 6 kV contact
± 8 kV air
± 2 kV for power supply lines ± 2 kV for power supply lines
± 1 kV line(s) and neutral
<5 % U (>95 % dip in U )
T T
for 0.5 cycle
40 % U (60 % dip in U )
T T
for 5 cycles
70 % U (30 % dip in U )
T T
for 25 cycles
<5 % U (>95 % dip in U )
T T
for 5 s
3 A/m
Compliance level
± 6 kV contact
± 8 kV air
± 1 kV line(s) and neutral
<5 % U (>95 % dip in U )
T T
for 0.5 cycle
40 % U (60 % dip in U )
T T
for 5 cycles
70 % U (30 % dip in U )
T T
for 25 cycles
<5 % U (>95 % dip in U )
T T
for 5 s
3 A/m
82
Electromagnetic environment – guidance
Floors should be wood, concrete or cera-
mic tile. If floors are covered with synthetic
material, the relative humidity should be at
least 30 %.
Mains power quality should be that of a typi-
cal commercial or hospital environment.
Mains power quality should be that of a typi-
cal commercial or hospital environment.
Mains power quality should be that of a typi-
cal commercial or hospital environment.
If the user of the IH 40 requires continued
operation during power mains interruptions,
it is recommended that the IH 40 be powe-
red from an uninterruptible power supply or
a battery.
Power frequency magnetic fields should be
at levels characteristic of a typical location
in a typical commercial or hospital environ-
ment.