instructions on turning on therapy, go to
"Turning your therapy on or off" on
page 46.
Note: If a power-on-reset (POR) screen
appears on the patient programmer, see
Table 4.1 on page 97.
Activating settings to allow
therapy on during the MRI scan
Depending on your therapy settings, your
clinician managing your neurostimulation
system may create a new group that should
be activated prior to your MRI scan. This will
allow your system to safely remain on during
the scan.
If your clinician managing your
neurostimulation system creates a new group
setting so that therapy can remain on during
your MRI scan, the new group can be
activated with the patient programmer (see
page 93) or the clinician programmer (see
page 94).
92
English 37642 2015-04