Patient programmer alert
Your doctor may set up an alert on the
patient programmer to remind you to check
your neurostimulator battery once a day
(rechargeable neurostimulator batteries only).
Note: For nonrechargeable neurostimulator
batteries, your doctor may set up this alert for
you when your battery is near its end of
service.
The default setting for the alarm is 11:00 a.m.
However, your doctor may change this to a
different time of day if appropriate.
The alert time is based on the time set for the
patient programmer. To adjust this time, see
Table 2.6 on page 56.
The patient programmer alert beeps for 30
seconds, with a pause every 10 seconds.
The Patient alert screen displays while the
alarm is beeping (see Figure 2.19). The
Patient alert sounds even if the audio
preference is turned off.
59
37642 2015-04 English