Inserting And Connecting The Flight Battery - Reely Sky Slowflyer Rtf Notice D'emploi



11. Inserting and Connecting the Flight Battery

Push the charged flight battery (1) into the two battery holders from the
rear according to the figure.
Important!
For correct compliance with the centre of gravity, the battery
must be pushed as far towards the front battery holder (2)
as possible.
Then switch on the transmitter. Observe that the control lever for the
motor function is in the bottom position.
Connect the flight battery to the model connection line's plug (3) with
protection against polarity reversal.
Once the receiver recognises the transmitter's control signals, the elevator
and rudder servo will deflect briefly and then run into the position last set
by trimming.
28
Figure 5