Parkside PDBNP 14 A1 Traduction Des Instructions D'origine page 41

♦ Check if the diameter of the attached mouthpiece
mandrel diameter of the determined rivet size.
♦ If it does not, unscrew the front connector
spanner , if necessary.
CAUTION!
► Ensure that the appliance is disconnected from the compressed
air source before you fit or remove the front connector
♦ If necessary, unscrew the mouthpiece
using the assembly spanner
spare mouthpiece
♦ To attach the front connector
feel minor resistance) and tighten it by hand.
♦ Tighten the front connector
♦ Reconnect the appliance to the compressed-air supply.
♦ Place the rivet body in the drill hole.
♦ Slide the appliance over the rivet
ed into the mouthpiece
♦ Pull the trigger
from the rivet body and the rivet joint is established permanently.
The mandrel falls into the pin collector
If necessary, repeat the process until the mandrel has been fully
separated from the rivet body.
♦ Proceed in the same way with the other rivets
♦ Empty the pin collector
♦ When you have finished working, disconnect the appliance from
the compressed air source.
│ GB │ IE
■ 38
into the front connector
, press it onto the thread (you will
using the assembly spanner
.
. The mandrel is pulled into the device, detached
regularly.
using the assembly
from the front connector
. Afterwards, screw the correct
and tighten it.
until the mandrel is fully insert-
.
.
PDBNP 14 A1
matches the
.
.