Before Use; Lubrication - Parkside PDBNP 14 A1 Traduction Des Instructions D'origine

■ Ensure that the maximum permissible pressure stated on the ma-
chine is not exceeded.
■ Never carry pneumatic machines by the hose.

Before use

NOTE
► The rivet gun may only be operated on cleaned, oil-atomised
compressed air and may not exceed the maximum operating
pressure of 6.3 bar at the appliance. The compressor must be
fitted with a pressure reducer to regulate the working pressure.
► Note that the maximum working pressure may not be exceeded.
An excessive working pressure does not mean increased output;
it merely increases the air consumption and accelerates appli-
ance wear. Always comply with the technical information.
► Wind the sealing tape

Lubrication

NOTE
► Regular lubrication is particularly important to avoid friction and
corrosion damage. We recommend using a suitable special oil
for compressed air appliances (e.g. Liqui Moly compressor oil).
–
Lubrication with mist oiler
A mist oiler (not supplied) continuously and optimally
lubricates the appliance as a preparation stage after the
pressure reducer. A mist oiler gives off fine drops of oil into
the air flow and thus guarantees regular lubrication.
–
Manual lubrication
If you do not have a mist oiler, lubricate the appliance be-
fore every use or longer work sessions. To do this drip 3–4
drops of special oil for compressed air appliances into the
lubricant opening
PDBNP 14 A1
supplied around all threaded connectors.
.
GB │ IE │
35 ■