Installing The Sensor; Figure 3-8 Sensor Callouts; Figure 3-9 Sensor Installation - Siemens SITRANS F FUG1010 IP65 NEMA 4X Instructions De Service

Installing the Sensor

1. Take either sensor and apply a continuous lengthwise 3mm (1/8-inch) bead of coupling
FUG1010 IP65 NEMA 4X Quick Start
Operating Instructions, 06/2014, A5E02951527-AC
compound across the center of the sensor emitting surface.
①
F-Connector
②
Angled Edge
③
Sensor
Figure 3-8 Sensor Callouts
①
Front View
②
Spring Clip (Not present on some
models)
③
Sensor Clamping Screw
④
Spacer Bar
⑤
Mounting Frame
Figure 3-9 Sensor Installation
3.5 Sensor Installation
④
Front Face
⑤
Emitting Surface
⑥
Coupling Compound
⑥
Pipe
⑦
Mounting Strap
Note: Optional 2nd Mounting Strap
shown. Larger pipes over 76cm (30
inches) may need additional support..
⑧
Spacer Bar Platform and Clamping
Screw
⑨
Spacer Bar Reference Hole
⑩
Orientation for Single Beam Sensor at
9 o'clock position
⑪
Orientation for Dual Beam Sensor at
10 & 2 o'clock positions
Connecting
43