Installing The Sensor - Siemens SITRANS F FST020 IP65 NEMA 4X Instructions De Service

Save/Rename Site procedure
Whenever new site configurations are added to an existing site that site must be saved again
to retain the new site changes.
1. To save all programmed data to site, press <Left Arrow> key and then scroll up to
2. Press <Right Arrow> key and scroll to [Save/Rename Site].
3. Press <Right Arrow> key and then <ENTER> to save all programmed data to site.
4. To return to the top menu level, continue to press the <Left Arrow> key.
3.3

Installing the Sensor

Reflect and Direct Mounting Modes
Reflect and Direct mounting modes are supported for clamp-on sensors. The transmitter
recommends a mounting mode after analyzing your pipe and liquid data entries. This Quick
Start illustrates a typical sensor setup using the Reflect Mode.
Note
For Direct Mount refer to the Operating Instructions manual.
Mounting Supplies
The following items will be needed to mount the sensors (most are supplied):
● Flat blade screwdriver
● Mounting Frames or Mounting tracks
● Tape, chalk and a ruler or measuring tape
● Mounting Straps
● Spacer Bar
● Mounting Guide (for Direct Mount)
● Ultrasonic coupling compound
● Sensors (matched set)
FST020 IP65 NEMA 4X Quick Start
Operating Instructions, 03/2012, A5E03086489-05
[Channel Setup].
Connecting
3.3 Installing the Sensor
25