Sony RM-IP10 Mode D'emploi page 7

H PRESET button
Hold down this button and press one of the
GROUP/POSITION buttons. The current camera
settings are then stored in the memory of the
camera corresponding to the pressed GROUP/
POSITION button.
I RESET button
Hold down this button and press one of the
GROUP/POSITION buttons. The memory of the
camera corresponding to the pressed GROUP/
POSITION button is then cleared to the factory-
preset condition.
When multiple cameras are connected with RS-
232C/RS-422, the camera addresses are set by
holding down this button and pressing the POWER
button.
J GROUP indicator
K GROUP button
While holding down this button, the GROUP
indicator lights and the GROUP/POSITION button
of the group number that is being operated lights in
yellow.
*
The GROUP button works only for the LAN
connection.
* When the upper indicator next to the SHIFT
button is lit, the GROUP/POSITION buttons are
for group numbers 1 to 8. When the lower
indicator next to the SHIFT button is lit, the
GROUP/POSITION buttons are for group
numbers 9 to 16.
L BACK LIGHT button
Press this button to enable the backlight
compensation function of the camera. Press it again
to disable the function.
Hold down the SHIFT button and press this button
to enable the spotlight compensation function. This
function adjusts the exposure to a darker level if a
portion of the subject is brightly lit.
To disable spotlight compensation, hold down the
SHIFT button and press this button again.
Notes
• The backlight compensation or spotlight
compensation function may not work depending
on the camera or exposure mode of the camera.
For details, refer to the Operating Instructions
supplied with that camera.
• The backlight compensation and spotlight
compensation exposure mode of the BRC-H900
differ from the FULL AUTO exposure mode.
Spotlight compensation and backlight
compensation adjustment cannot be performed at
the same time.
M PAN-TILT RESET button
Press this button to reset the pan/tilt position of the
camera to its initial condition.
N ONE PUSH AWB button
When the ONE PUSH white balance mode is
selected on the camera, press this button to perform
the one-push white balance adjustment.
Note
While the one-push white balance adjustment is
being performed, the joystick operations (including
stop operation) do not work.
O POSITION indicator
P MENU button
Press this button for about one second to display the
menu of the camera, return to the main menu, or
turn off the menu.
Q Joystick
The joystick is used for pan/tilt and zoom
operations. Select the camera you want to control
using the CAMERA buttons and operate the
joystick.
Panning and tilting
When you incline the joystick right or left, the
camera pans. When you incline it forward or
backward, the camera tilts.
The pan/tilt speed changes according to the angle of
the inclination.
When you release the joystick, the camera
movement stops.
Zooming
When you turn the dial on the upper part of the
joystick clockwise, the subject becomes larger
(zoom in). When you turn it counterclockwise, the
subject becomes smaller (zoom out).
To face the camera back to the front
When you press the button on the top of the joystick
for one or two seconds, the pan/tilt/zoom are reset
and the camera returns to face directly ahead.
R SHIFT button and indicators
When pressing the SHIFT button, the lower
indicator lights and the GROUP/POSITION
buttons can be used for group/position numbers 9 to
16. If you release the SHIFT button, the upper
indicator will light and the GROUP/POSITION
buttons can be used for group/position numbers 1 to
8.
Location and Function of Parts
7
GB