Storing The Camera Settings In Memory - Presetting Feature; Setting The Speed Of The Camera Moving To A Preset Position - Sony RM-IP10 Mode D'emploi

We recommend that you check the stored settings
by recalling the preset.
To recall the stored settings
Press the GROUP/POSITION button in which you have
stored the settings.
For POSITION 9 to 16, hold down the SHIFT button
then press the GROUP/POSITION button.
To cancel the preset memory
While holding down the RESET button (for POSITION
1 to 8) or the SHIFT and RESET buttons (for
POSITION 9 to 16), press the GROUP/POSITION
button from which you want to cancel the settings.
While holding down (for POSITION 1 to 8)
POSITION
Press a GROUP/POSITION button.
RESET
PRESET
1 2 3
SHIFT
9 10 11
While holding down (for POSITION 9 to 16)
The pressed button flashes during canceling of the
settings. Flashing stops when the settings have been
canceled.
Notes
• When the power is turned on, the camera starts with
the settings stored in POSITION 1.
• If you want to retain the previous pan and tilt positions
when the power is turned off and turned on again, store
those positions in POSITION 1.
• When you are storing or canceling the settings in one
POSITION, you cannot call up, store or cancel the
settings in another POSITION.
4 5 6 7 8
12 13 14 15 16
Setting the speed of the camera
moving to a preset position*
* The moving speed is stored in the internal memory of
the camera. BRC-H900, BRC-Z700, and BRC-Z330
are compatible with this function.
You can select the panning/tilting speed when the
camera moves to a preset position.
1
Press the CAMERA button to select the camera
whose speed you want to set.
To change camera group number (for IP
connection)
Press any GROUP/POSITION button while
holding down the SELECT button. (For selecting 9
to 16, select the camera group number while
holding down the SHIFT button.)
2
Press the GROUP/POSITION button for which you
want to set the speed for more than one second.
All the CAMERA buttons, 1 to 7, flash.
3
Press one of the CAMERA buttons to select the
speed.
CAMERA Panning/tilting speed
button
BRC-Z700,
BRC-H900
1 1 degree/sec.
2 2.2 degrees/sec.
3 4.8 degrees/sec.
4 11 degrees/sec.
5 23.3 degrees/sec.
6 43 degrees/sec.
7 60 degrees/sec.
(default)
Now the camera will move to the position preset to
the pressed GROUP/POSITION button with the
selected speed.
To set the speed of the camera moving to
a preset position between 9 and 16
To set the speed of the camera moving to a preset
position between 9 and 16, hold down the SHIFT button
and press the corresponding GROUP/POSITION
button.
Storing the Camera Settings in Memory – Presetting Feature
BRC-Z330
1.3 degree/sec.
3.4 degrees/sec.
5.4 degrees/sec.
11.6 degrees/sec.
23.9 degrees/sec.
43.4 degrees/sec.
60 degrees/sec.
(default)
19
GB