Settings In The Menu - Wilo Stratos Notice De Montage Et De Mise En Service

8.2.3 Settings in the menu

The following menus appear in succession on the pump display:
(horizontal representation of display)
Single pump mode: Setting when first used / Menu order during standard use
LC display
If no setting is made in the subsequent menus for 30s,
the basic setting
Installation and operating instructions Wilo-Stratos/-D/-Z
Setting
After switching on the module, all symbols appear
on the display for 2 seconds. The current setting
then engages.
Current (basic) setting (factory default):
H 18.0 ft • i.e., present differential pressure
re-appears in the display.
setpoint H = 18.0 ft at same time ½
S
H (factory setting depending on
max
s
pump type)
• Control mode Δp-v
• Pump runs in control mode, setback
operation disabled
(see also menu item
• Not shown with single pumps
The differential pressure set point can
be altered by turning the control button.
The new differential pressure set point
flashes.
The new setting is stored by pressing
the button briefly.
If no button is pressed, the previously
set flashing differential pressure set
point returns to the previous value after
30 seconds.
Press control button for > 1 second.
The next menu point
English
).
appears.
21