Personnel Qualifications; Danger In The Event Of Non-Observance Of The Safety Instructions; Safety Consciousness On The Job; Safety Instructions For The Operator - Wilo VeroLine-IPL Notice De Montage Et De Mise En Service

English
2.2

Personnel qualifications

2.3 Danger in the event of non-
observance of the safety
instructions
2.4

Safety consciousness on the job

2.5

Safety instructions for the operator

24
Information that appears directly on the product, such as:
• Direction of rotation arrow,
• Rating plate
• Warning sticker
Must be strictly complied with and kept in legible condition.
The installation, operating and maintenance personnel must have the
appropriate qualifications for this work. Area of responsibility, terms
of reference and monitoring of the personnel are to be ensured by the
operator. If the personnel are not in possession of the necessary
knowledge, they are to be trained and instructed. This can be accom-
plished if necessary by the manufacturer of the product at the request
of the operator.
Non-observance of the safety instructions can result in risk of injury
to persons and damage to the environment and the product/unit.
Non-observance of the safety instructions results in the loss of any
claims to damages.
In detail, non-observance can, for example, result in the following
risks:
• Danger to persons from electrical, mechanical and bacteriological
influences
• Pollution of the environment due to leakage of hazardous materials
• Damage to property
• Failure of important product/unit functions
• Failure of required maintenance and repair procedures
The safety instructions included in these installation and operating
instructions, the existing national regulations for accident prevention
together with any internal working, operating and safety regulations
of the operator are to be complied with.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible
for their safety or where they receive instructions from such a person
as to how the device is to be operated.
Children should be supervised to ensure that they do not play with the
appliance.
• If hot or cold components on the product/the unit lead to hazards,
local measures must be taken to guard them against touching.
• Guards protecting against touching moving components (such as the
coupling) must not be removed whilst the product is in operation.
• Leakages (e.g. from a shaft seal) of hazardous fluids (e.g. explosive,
toxic or hot) must be conveyed away so that no danger to persons or
to the environment arises. National statutory provisions are to be
complied with.
• Danger from electrical current must be eliminated. Local directives or
general directives [e.g. IEC, VDE etc.] and local energy supply compa-
nies must be adhered to.
• The area near the pump unit must be kept free of contaminants to
eliminate the chance of a fire or an explosion due to contact of con-
taminants with hot unit surfaces.
• The instructions in this manual apply to the standard equipment
design. This book does not discuss all details or frequent deviations.
Additional information is available from the manufacturer.
• If there are any doubts about the function or setting of parts of the
equipment, contact the manufacturer immediately.
WILO SE 11/2017