Radiometer Analytical MeterLab PHM220 Mode D'emploi page 49

2. Press the Mode key for 4 seconds to enter the Edit mode. The
Edit mode has four categories: CALIBRATION, SAMPLE,
METHOD SETUP and CONFIGURATION. The data stored in
calibration, sample and method setup can be printed out
separately in the following way:
Select CALIBRATION, SAMPLE or METHOD SETUP using the
left or right arrow key. Press the down arrow key to enter the
chosen parameter data.
Press the Print key.
Examples of the three different printouts are shown below:
CALIBRATION
*** PHM220 pH Meter 657R00N003
pH parameters
* CALIBRATION *
Calibration Type
Number of Cal Buffers
Buffer No. 1
Buffer No. 2
Stability Criterion
Accept time
Zero pH limits
Sensitivity limits
Calibrate every
**************************************************************************
SAMPLE AT INTERVALS
*** PHM220 pH Meter 657R00N003
pH parameters
* SAMPLE *
Sample Result
Stability Criterion
Print Interval
Stop Print After
Store in GLP
pH alarm limits
Temperature alarm limits
**************************************************************************
(using a fixed selection of buffers)
: FIXED Selection of Buffers
: 2
: 4.005 pH (IUPAC)
: 10 pH (4-7-10)
: 50 mpH/min
: 200 s
: 5.8 pH and 7.5 pH
: 95 % and 102 %
: 24 hours
: At Intervals
: 50 mpH/min
: 30 s
: 10 min
: Final Result
: -9 . 0 p H to 23.0 pH
: -9 ˚ C to 99 ˚ C
16FEB95 9:15 ***
16FEB 10:15 ***
49
Printouts