Radiometer Analytical MeterLab PHM220 Mode D'emploi page 40

Store in GLP
ALL RESULTS
Store in GLP
NO RESULTS
Store in GLP
L AST RESULT
Min pH Alarm
-9.0 pH
Max pH Alarm
23.0 pH
Min Temp Alarm
-9 ˚C
Max Temp Alarm
99 ˚C
Return to the first Edit display by pressing the up arrow key or leave the Edit
mode by pressing the Mode, Cal, Sample, pH/mV or GLP key.
40
Chapter 3
Using the left or right arrow key, select what
results you would like to store in the GLP
table.
If you choose ALL RESULTS, the result
at the end of each interval will be stored
in the GLP table.
If you choose NO RESULTS, there will be
no results stored in the GLP table.
If you choose LAST RESULT, the very last
result will be stored to the GLP table.
If the pH of the sample is above the maximum
or below the minimum pH limits set, an alarm
message will appear on the display and on
printouts.
Range available: -9.0 to 23.0 pH
Min. and max. mV displays will appear if mV
has been selected in the mode display.
Range available: -1999 to 1999 mV
An alarm message will appear on the display
if the sample temperature is above the
maximum or below the minimum limits set.
Range available: -9 to 99˚C