Radiometer Analytical MeterLab PHM220 Mode D'emploi page 29

1.Meas.s
15
1. Date
15FEB95
If you wish to see further sample measurement results, press the
down arrow key and then use the left arrow key to move along
the text line.
5. To leave the GLP table, you can press the Mode, Cal, Sample
or pH/mV key.
Note: A reset does not erase the sample GLP table.
Sample measurement result data for a mV method are accessed in
exactly the same way as described above for a pH method. When mV
has been selected in the Mode display, the display shown below will
appear when the GLP key is pressed:
Press
Error
shows the measuring time in
UNSTAB
seconds, i.e. the stabilisation
time, the accept time or the time
taken before the result was ac-
cepted manually by pressing the
error has occurred during sample
measurement.
Press
Time
you to the last display in the
15:10
series for sample entry no. 1. The
date and time at which the sample
measurement was performed are
now shown.
mV Method Result Data
GLP: mV Data
. The next display
key. It indicates whether an
once more to bring
Starting up
29