Care And Maintenance - Festo DGC-8 Série Notice D'utilisation

DGC
9

Care and maintenance

Maintaining the band system:
Clean the band system if required with a soft cloth.
S
Avoid cleaning agents which will damage the band system of PU.
S
Excessive friction or the use of grease−solvent cleaning agents (e. g. soap
suds) will damage the grease layer.
Lubricate the surface of the band system if it no longer has a layer of grease.
S
Grease type: LUB−KC1.
Lubricating the guides of types G and GF:
Lubricate the guide rail of the DGC−8−G, if it no longer has a layer of grease,
S
but at the latest after every 3000 km or every 3 years.
Grease type: LUB−KC1.
Note that lubrication must be undertaken more often:
S
in dusty and dirty environments
with work strokes longer than < 50 mm
in ambient temperatures of > 40 °C.
The remaining sizes of types G/GF do not require any maintenance
(relubrication however is permitted).
Lubricating the guide of KF:
The lubrication intervals S
the loading of the guide.
1. Calculate the loading of guide F
the aid of the formula for combined load
ings (see Technical specifications") and
read the lubricating interval S
Fig. 29.
S Note that lubrication must be undertaken more often:
dusty and dirty environments
with work strokes of < 50 mm or > 2000 mm
at speeds of > 2 m/s
in ambient temperatures of > 40 °C.
S Always lubricate the DGC at the latest every 3 years.
44
depend on
int
with
ver
from
int
Fig. 29
Festo DGC 0901d English