Festo DGC-8 Série Notice D'utilisation page 34

DGC
Fastening the work load
Place the work load so that the tilting
S
torque of force F parallel to the movement
axis and the lever arm a remains low
( Techical specifications": M
è
With hard and stiff work loads:
Please note
If the slide becomes bent against a
buckled work load, the service life of
the guide will be reduced.
S Make sure that the mounting surface
of the work load is not bent more than
as follows:
Note the tightening torques when fastening the work load on the slide:
S
DGC−...
Tightening
torque [Nm] torque [Nm]
Fig. 12
Work loads with their own guide:
Adjust the guides of the work load and of the DGC so that they are exactly par
S
allel.
Only in this way can you avoid overloading on the slide (permitted forces
Technical specifications").
è
34
G/GF: 0.03 mm
KF/FA: 0.01 mm
M4 G
KF
M5
M6
M8
Fig. 10
, M , M ).
x y z
Fig. 11
8/12 18
2
2.5
3.5
a
25/32 40 50/63
6.5
10
Festo DGC 0901d English
F