elco AEROTOP SPLIT M-RX Guide D'installation page 55

Overview
Safety regulations
Binding indications and directives.
The construction and manufacture of
the heat pump complies with all Euro-
pean regulation directives (see EC de-
claration of conformity).
The power connection of the heat
pump must be carried out in com-
pliance with national appliance regula-
tions. In addition, it is necessary to com-
ply with the connection conditions of
the local energy provider.
Additional indications and instruc-
tions.
Functional or surface-ready heating
with the heat pump according to DIN
EN 1264 is only possible if taking into
account the aforementioned condi-
tions. After sizing the heat pump for
normal operations, it may not be pos-
sible to generate all heating necessary.
Please comply also with the following
instructions:
• Comply with regulations and ins-
tructions issued by the screed ma-
nufacturer of the screed mortar!
• Correct operations are possible
only with a system that has been
installed up to standards (hy-
draulics, electrical components,
settings)! Otherwise the screed
could be damaged!
Because overloading could cause
serious damages, it is forbidden to
activate the heat pump if the fol-
lowing conditions apply:
· construction drying out;
· System temperature < 25 °C . It
is recommended to heat with
the use of electrical resistance
installed
· unfi nished system (raw con-
struction);
· external doors and windows not
completed and closed.
In these cases, it is necessary to make
provisions for site heating.
Warranty terms
The warranty for heat pumps is valid for
24 months from the day of delivery.
For everything else, the sale, provision
and warranty conditions apply on the
basis of the order confi rmation. Our
warranty provisions shall be forfeit for
damages as a result of:
· improper use, misuse or noncom-
pliant use
· incorrect installation or commissio-
ning by the purchaser or third parties
· addition of parts from other manu-
facturers
· usage of the system with excessive
pressure or pressure outside the indi-
cated factory levels
· failure to comply with the instruc-
tions contained in the manual
Checks on delivery
The appliances are delivered on a woo-
den pallet, packed in cardboard. At the
time of delivery, please check that the
appliance wasn't damaged in transport
and that the equipment is complete.
If you do fi nd any damage, this must be
reported immediately on the transport
document with the following wording:
«Delivery accepted with reserved due
to obvious damages».
The utmost care has been used in ma-
nufacturing the heat pump. However,
during the manipulation of the evapo-
rator, it isn't possible to exclude a slight
bending of the single blades during
production. This does not constitute a
defect in the product.
For more information, please see pro-
duct description: high-effi ciency visible
evaporator.
55 / GB