Controls And Features; Extension Drawers; Wood Drawer Fronts; Interior Light - GE PCR06BATSS Manuel D'utilisation Et Instructions D'installation

Controls and Features

Full Extension Drawers
All of the full extension drawers pull out so bottles can
be conveniently added or removed.
Any of the full extension drawers can be removed to
store larger bottles.
To remove:
1. Pull the full extension drawer out to the
STOP position.
2. Push the tab on right drawer guide down while
pulling the tab on left guide up, and pull the drawer
out.
To replace:
1. Push the drawer slide arm back into the unit.
2. Pull the small slide sub-assembly completely
forward.
3. Insert the sides of the drawer back into the guides.
4. Push until the tabs lock into place.
NOTE: Make sure the tabs on the full extension drawer
guides are fully engaged before loading any bottles.
Pull the drawers out all the way to the STOP position
and push back in several times to make sure locking

Wood Drawer Fronts

The full extension drawer fronts on the beverage
center and wine chiller are unfinished beech wood.
the wood.
• The drawer fronts may be stained and sealed to
match adjacent cabinetry. The tinted glass will make
the stained wood appear darker. A true color match
can be seen only when the door is opened.

Interior Light

The interior light makes it easy to view your wine and/
or beverage labels and enhances the display of your
collection.
on only when the door is opened. When the switch is
in the ON position, the light remains on continuously
do not store a bottle on the top shelf directly under
the light. Remember to turn off the light when it is no
longer needed.
49-60466-6
tabs are properly engaged.
Sub-assembly
To replace, push drawer
slide arm back into unit
• Apply the stain and sealer according to the
manufacturer's instructions. To avoid unpleasant
odor, keep the door open to ventilate and allow
the stain/sealer to dry completely before using the
product.
NOTE: Natural wood may vary slightly in grain and
color.
Tab (push
tab down on
right drawer
guide, pull
tab up on left
drawer guide)
Sub-assembly
Pull small slide sub-assembly
completely forward