Controls And Features: Beverage Center; Glass Shelves; Loading; Temperature Control - GE PCR06BATSS Manuel D'utilisation Et Instructions D'installation

Refroidisseur à boissons et vin
Masquer les pouces Voir aussi pour PCR06BATSS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Controls and Features - Beverage Center

Temperature Control

The operating temperatures of the beverage center
range from the low forties to the mid fifties. This
appliance is not a refrigerator and does not maintain
(32°C).
As with any refrigeration-type product, there is a slight
temperature variance at different locations within the
cabinet.
The coolest area will be in the lower part of the
cabinet.
The cooler area will be in the middle section.
The upper part of the cabinet is the warmest section.
When the temperature is adjusted, allow 24 hours for

Glass Shelves

Tempered glass shelves in the beverage center unit
are removable for easy cleaning or for storing larger
items.
To remove a shelf, open the door completely to avoid
potential damage to the gasket. Lift up on the back of
the shelf slightly. Tilt the shelf to one side at an angle
while pulling forward.
To replace a shelf, open the door completely to avoid
potential damage to the gasket. Tilt the shelf to one
side at an angle and slide toward the back wall, placing
one side onto the shelf support. Place the other side
onto the opposite shelf support. Ensure rear locking
tabs are engaged. When installed properly, the shelf
will not slide forward when gently pulled.
Loading Tips and Suggestions
• The bottom two full extension drawers hold six
bottles each and are loaded with necks facing the
rear. Tall bottles should not be loaded on the bottom
drawer because they may prevent the door from
closing.
beverage center shelves or full extension drawers.
They could seriously injure themselves and possibly
49-60466-6
To set the control, turn
it to the midpoint setting
the beverage center is
loaded, allow at least 24
hours before making any
adjustments to the initial
setting.
NOTES:
• This unit is designed for storing and cooling
beverages. It is not intended for the storage of
perishable foods.
• The lowest temperatures are found on the lower
shelves/racks and toward the rear of the shelves/
racks.
To remove, lift up on the
back of the shelf
Place in slots when replacing
the shelf
Bottom drawer arrangement
Tilt the shelf at an angle
while removing or replacing
cause
damage to
the beverage
center.
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pcr06watss

Table des Matières