Leister VARIANT T1 Instructions D'utilisation page 21

Operating Instructions
Read the operating instructions carefully before starting
the device and keep them for future reference.
Leister VARIANT T1
Hot-air welding machine
Application
The device should be used only in well-ventilated rooms. If necessary, work should be carried out with a fume hood
or personal protective equipment. Take care to ensure that no material burns during the welding process. Check
with the materials manufacturer regarding additives hazardous to health. The statutory regulations regarding health
protection of the respective country are to be applied.
• Handheld hot-air welding machine for overlap, hem and piping welding of tarpaulin material
(PVC and similar materials).
• Processing only in well ventilated rooms
Warning
Caution
FI
(Translation of the original operating instructions)
Danger of death when opening the device, as live parts and connections are
exposed. Remove the plug from the socket before opening the device.
Risk of fire and explosion if hot-air welding devices are used incorrectly, especially
in the vicinity of flammable materials and explosive gases.
Danger – can cause burns! Do not touch the welding nozzle while it is hot.
Allow the device to cool.
Do not direct hot-air stream towards people or animals.
Connect device to power socket with protective earth conductor. Any break in
the protective earth conductor inside or outside the device is dangerous!
Only use extension cables with protective earth conductor!
When using the device on building sites, a residual current circuit breaker is
essential for the safety of persons there.
The device must not be left unattended when in use.
Heat can reach combustible materials which are out of sight.
The device may only be used by trained personnel or under their supervision.
Children may not use the device under any circumstances.
Keep away from wet and damp areas.
Device must not be lifted at additional weight.
GB
21