Hendi 229064 Mode D'emploi page 7

Temperature setting:
• Press TIME/TEMP button once in standby mode
to check the temperature setting, when the tem-
perature is blinking in the display, you can also
press button + or - to increase or decrease oper-
ation temper ature setting. (Default temperature:
70°C, range: 35°C ~ 70°C, interval is 5°C).
• The user should press START/STOP button to
confirm the temperature setting.
Time setting:
• Press TIME/TEMP button twice in standby mode,
then the timer is blinking in the display, the user
can press button + or - to increase or decrease
operation time. (Range: 00:30 ~ 24:00, interval is
30 minutes).
• The user should press START/STOP button to
confirm the timer setting.
KEEP WARM mode:
• The display will show "KEEP WARM" if pressing
"KEEP WARM" button. The machine will keep
working for extra 24 hours in 35°C temperature
after finishes dehydrating.
• When the countdown timer finishes, the display
FAST/RAW mode:
• In FAST mode, the temperature is 70°C and the
timer is 10 hours. The display will show "FAST".
Switch to STANDBY mode
• If the user did not press START/STOP button in
5 seconds after setting, the machine will jump
back to standby mode. Only TEMP/TIME button
Time setting end up
• When the setting time counts down to 00:00, the
heating elements stop working first. The cool-
ing fan will still continue running for about 10
seconds and 20 times of "beep" sound from the
buzzer will be heard to remind the user the oper-
ation is finished.
• If you want to check the temperature that was
set, press TEMP / TIME button once and the set
temperature will be shown on the LED display.
• During the operation process, you can check
or change the time and temperature setting by
pressing the TEMP / TIME button. And then press
button + or - to increase or decrease the temper-
ature and time setting.
• Then, the appliance will start operation and re-
maining time will be shown on the LED display.
The fan at the rear side of the appliance will start
rotation.
will show 88:88 and the heating element will
switch off. The fan will continue running for 10
seconds and the machine will beep 20 times to
remind the user. After beeping 20 times, the ma-
chine will go back to standby mode.
• In RAW mode, the temperature is 45°C and the
timer is 24 hours. The display will show "RAW".
will be blinked in blue and the LED screen is fully
displayed.
• 'End' will be shown on the LED display and the
appliance is in STANDBY mode.
• Unplug the appliance and wear gloves (not in-
cluded) if necessary to take out the food.
EN
7