Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Approximate Data: xxx generates
9-
BTU / h (shown only when the
G10 is running.
9
Each time "OPEN DOOR ..." APPEARS
YOU MUST OPEN AND CLOSE THE
DOOR and perform the "RESET
DOOR" function if desired. This can be
requested more than once.
The whole circuit of the pellet feed
must be filled;
The hopper, the section of the
auger tubing and the pellet chute
fall that leads to the combustion
chamber.
This is normally done during initial
use or in maintenance.
page 47
In the table (list) the alarm or alarms flash. Automatically, the system always
returns to the page of the alarm that must be set first. Each of the alarms gives
access to a help page indicating the steps to be taken to solve each one.
When "OPEN DOOR TO RESTART PELLET"
appears on the screen, you must open the door
and check inside the combustion chamber that
everything is functional and then do the
"RESET DOOR" function. If this function is not
performed, the pellet system will start only after
five (5) hours. Remaining minutes shown.
FILLING PELLET CHUTE (FALL)
Also see the section Operating and Alarm Help
page 52.
1- Fill the hopper with dry wood pellets, as
specified in the user's manual.
2- Open the furnace door.
3- HOLD continuously upwards for about
TEN (10) to TWENTY (20) MINUTES,
the button «RESET DOOR».
This will activate the hopper auger.
4- Release the button when the pellet
starts to fall in the combustion chamber.
FUNCTION «RESET DOOR»
1-Open the door of the furnace.
2-Close the door.
3-Hold upwards the «RESET DOOR» button at
least 10 seconds.
5- Close the door.
The furnace pre-programming will activate
the pellet heating FIVE (5) HOURS after
EVERY opening / closing of the furnace
door, assuming a wood filling.
Or:
6- After closing the door, hold the "RESET
DOOR" button upwards about TEN (10)
SECONDS.
The pellet ignition cycle will start according
to temperature demand you have saved
on your thermostat.
ABPLUS-TREM-290519
Publicité
Table des Matières
