Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
TOUCHSCREEN
COMPONENTS SUPPLIED TOUCHSCREEN AirBilo
Also see operating and alarms section on pages 52 to 57.
1-
Check the box of parts provided for this option.
A.
1 Touchscreen
B.
1 Network cable 10 feet
C. 1 Connetion cable
2-
Tools required for installation.
«Philips» screwdriver
INSTALLATION OF TOUCHSCREEN
Step 1 :
Choose location of the touch screen. It is not
necessary to install the touch screen near
the furnace. Allow sufficient cable length for
connection with the furnace.
Ground floor
wall
Step 4 :
Fully insert the end of the connecting wire (C)
into the opening of the PLC.
page 45
TOUCHSCREEN
(AirBilo WOOD-PELLET FURNACE)
Step 2 :
(if already factory assembled continue
at step 8)
2a) Cut off power.
2b) Remove the middle cover of the
control panel of vent box.
Suggestion
only
Step 5 :
Connect the "Molex" end of the cable (C)
to the location indicated
«ECRAN TACTILE».
A.
B.
Step 3 :
Using an appropriate tool, lift the white
cover close to the PLC screen and remove
it.
Step 6 :
On the control panel, remove rectangular
shaped knockout "penny" off where
indicated «ECRAN TACTILE».
ABPLUS-TREM-290519
C.
Publicité
Table des Matières
