L.S. BILODEAU AirBilo Manuel De Fonctionnement Et D'installation page 40

Step 53:
Connect the "Molex" connection of the
motor with the one of the motor bracket.
Step 56:
Insert the assembled auger pipe (D), to the
bottom of the box in the back of the hopper.
Step 59:
Replace the screw ferrule part to secure the two
sections together. Make sure the seal is in place.
SECURITY COMPONENTS AND CONNECTION
DANGER : Electric shock risk
Déconnecter les sources d'alimentation avant toute intervention
IMPORTANT: These instructions are for the exclusive use of licensed service technicians, to which the responsible authorities
have issued the necessary licence and which are the only authorized to do the maintenance and repairs to the AirBilo furnace
and its different components. Above all it is important to remember that all system components can influence the proper and safe
operation of this appliance and that the service technicians must be familiar with the particularities of the appliance before
proceeding with any troubleshooting or repair.
INSTALLATION OF THE DOOR SWITCH
Step 60:
Unscrew the nuts and fix the door switch (A) to the back side of the
door handle bracket.
page 39
Step 54:
Place the motor cover (Dd) and screw on
with four (4) screws supplied.
Step 57:
Orient auger tube (D) so that the
"stainless" pipe section joins the
extension elbow of the pellet chute.
Can cause injury or death
Step 55:
INSTALLATION of the pellet feeding PVC tubing
(auger) section.
Step 58:
Ensure that the gasket seal is in right place
and fix the ferrule screw.
Step 61:
Fix towards TOP, the door switch
electrical wire using wire clips
provided. Unscrew three (3) screws
from front capping of the device and
two (2) screws on the side to bring
the electrical wire above the
ventilation box. Insert the excess wire
in the wire hiding-cover, keeping
enough length for connection.
ABPLUS-TREM-290519