Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
N.
1 switch plate
O.
1 smoke evacuator with smoke pipe-connecting section
P.
1 electronic fan limit
Q.
1 chimney probe
R.
1 mechanic fan limit
S.
1 control panel
T.
1 door switch
U.
1 thermostat
V.
1 bag of screws and wire clips
W. 1 wire hiding cover (for vent box)
X.
1 touchscreen with wiring
2-
Check the hopper and box parts supplied inside for pellet heating option. (images are not to scale and are indicative only)
3-
Tools needed for installation
• Screwdriver «Philips»
• 2 keys 7/16"
VENT BOX PREPARATION
INSTALLATION OF CONTROL PANEL, OF FILTER FRAME AND REMOVABLE PANEL
If the control panel has already been installed,
Step 4:
If necessary, to facilitate access, unscrew and
remove the large top panel or the filter frame of
the "G10" fan section.
or
page 33
• Drill with «Philips» driver and metal bit 1" and 1/2"
• Level
continue with step 8.
Step 5:
5a) Insert the control panel (S) in the smaller section of the vent box. THE SIDE WITH
"G10" CONNECTING WIRES MUST BE ORIENTED TOWARDS
THE "G10" FAN to connect it.
5b) If necessary unscrew the middle cover of the control panel (S).
"G10"
P.
R.
Q.
V.
W.
R. is supplied with
furnace component
box
X.
ABPLUS-TREM-290519
Publicité
Table des Matières
