John Bean B600 Manuel D'utilisation page 88

88
26
5-55
26
5-56
26
5-57
5-58
5-59
Operation
Fig. 5-55 Minimization "Un.6"
 Rotate the wheel into marking position following
the arrows.
 In this position mark the tire, on the outer side of
the wheel, precisely above the main shaft.
 Confirm by pressing the key 26.
The Minimization "Un.7" screen (Fig. 5-56) is displayed.
Fig. 5-56 Minimization "Un.7"
 On the tire changer, turn the tire relative to the
rim until the valve is aligned with the mark made
on the tire.
 Confirm by pressing the key 26.
The Minimization "Un.8" screen (Fig. 5-57) is displayed.
Fig. 5-57 Minimization "Un.8"
 Clamp the wheel on the balancer.
 Rotate the wheel such that the valve is exactly
perpendicular to and above the main shaft.
 Enter the valve position by pressing the key 26.
The Minimization "Un.9" screen (Fig. 5-58) is displayed.
Fig. 5-58 Minimization "Un.9"
START is signalled on the screen.
 Spinn the wheel.
A measuring run is performed.
The screen Minimization "Un.10", outside (Fig. 5-59)
or the screen Minimization "Un.10", inside (Fig. 5-61)
is displayed.
Reading H 0
Optimum condition has been achieved and cannot be
improved.
 Continue as shown on screen BALANCING
(Fig. 5-51).