John Bean B600 Manuel D'utilisation page 84

84
26
5-49
5-50
5-51
5-52
Operation
Reading of error code E9
If E9 is read out, at least one error was made with
respect to the sequence of operations when performing
Optimization (System messages
 Abort the Optimization program by pressing the
STOP key and, if desired, start Optimization once
again.
Fig. 5-49 Optimization "OP.12"
(4th measuring run of tire/rim assembly)
 Clamp the wheel on the balancer.
 Rotate the wheel such that the valve is exactly
perpendicular to and above the main shaft.
 Confirm the valve position by pressing menu key
26.
The Optimization "OP.13" screen (Fig. 5-50) is
displayed.
Fig. 5-50 Optimization "OP.13"
START is displayed on the screen.
 Spinn the wheel.
A measuring run is performed.
The BALANCING screen (Fig. 5-51) is displayed.
Finish weight Optimization
Fig. 5-51 BALANCING
 Balance the wheel according to the readings.
If the wheel running conditions are optimal, the
following codes can be displayed (Fig. 5-52):
H0 Wheel running conditions cannot be improved by
Optimization.
H1 Further Optimization not recommended but
feasible.
H2 Weight minimization is recommended, Optimization
can achieve no further improvement.

7.1).