John Bean B600 Manuel D'utilisation page 82

82
26
5-46b
29
5-47
26
5-48
26
5-49
5-50
Operation
Fig. 5-46b Optimization "OP.10", outside
 Rotate the wheel into marking position following the
arrows.
 In this position provide a double mark on the tire
outer side exactly perpendicular to and above the
main shaft.
 Confirm by pressing menu key 26.
The Optimization "OP.11" screen (Fig. 5-48) is
displayed.
Fig. 5-47 Optimization "OP.10", inside
If the tire cannot be turned over on the rim (e.g.:
Asymmetrical and Directional),
press the menu key 29, then


continue as shown on screen Optimization
"OP.10" (Fig. 5-46b).
If the wheel can be turned over on the rim;
 Rotate the wheel into marking position following the
arrows.
 In this position provide a double mark on the inside
of the tire, exactly perpendicular to and above the
main shaft.
 Turn over the tire over on the rim (tire changer).
 Confirm by pressing menu key 26.
The Optimization "OP.11" screen (Fig. 5-48) is
displayed.
Fig. 5-48 Optimization "OP.11"
 Readjust the tire on the rim such that the double
mark coincides with the valve (use tire changer).
 Confirm by pressing menu key 26.
The Optimization "OP.12" screen (Fig. 5-49) is
displayed.