Dometic PERFECTVIEW CAM 50 Instructions De Montage Et De Service page 19

CAM50
Creating a through-hole for the camera connection cable
(fig. d, page 6)
I
NOTE
If possible, use available openings – such as ventilation grilles – to feed
the connection cables through. If there are no existing openings, you
must drill a hole with a 16 mm diameter.
A
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill head to
come out
➤ Drill a hole of Ø 16 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
Mounting the camera
A
NOTICE! Risk of damage!
Only use the screws supplied to mount the camera in the camera
bracket. Longer screws will damage the camera.
➤ Push the camera into the camera bracket.
➤ Attach the camera loosely with the two screws M3 x 6 mm in the slots (fig. e,
page 6).
➤ Align the camera provisorily so that the lens is at an angle of approx. 50° to the
perpendicular axis of the vehicle (fig. f, page 7).
A
NOTICE! Risk of damage!
Never mount the camera without the camera guard.
➤ Push the camera guard over the camera (fig. g, page 7)
EN
Mounting the camera
19