Installation: Control Panel - Nice HSCU2 Instructions Et Avertissements Pour L'installation Et L'utilisation

4.4 - INSTALLATION: Control panel

(models HSCU2GC - HSCU2C and HSCU2GW - HSCU2W)
4.4.1 - Warnings
Before proceeding with installation carefully read paragraphs 4 .1 - 4 .2 - 4 .3 .
Caution! – For HSCU2GC and HSCU2GW: do not crush or bend the
GSM antenna cable.
4.4.2 - INSTALLATION
01. Open the container, and remove the protective mask (fig. 7-A) and then
the cover (fig. 7-B);
02. Release the side hook to rotate the control panel's: see fig. 8 per mod .
HSCU2C and HSCU2W - see fig. 8A for mod . HSCU2GC and HSCU2GW;
03. Ensure that the memory board is correctly inserted in the internal connec-
tor guides (fig. 9) .
In control panel models HSCU2GC and HSCU2G (with GSM), also
insert the SIM card (fig. 10);
04. Before securing the container, you can activate the blade proofing system
on the rear tamper (fig. 11):
a) remove part "a" as shown and set it aside
b) remove part "b" as shown and discard it;
05. For models HSCU2GC and HSCU2C: set up the cable hole (fig. 12) and
run the power cables through it (fig. 13);
06. Restore the control panel body to its holder (fig. 14);
07. Mark on the wall the 3 mounting points indicated in fig. 15 and the blade-
proofing system hole indicated as detail "a" (fig. 15);
08. Drill the wall at the 3 marked points and insert the provided wall plugs (fig.
16) . For the blade-proofing system, drill the 4th hole and fit the anchor plug
and part "a" previously set aside (fig. 16);
7A
8A
12 – English
7B
x 4
09. Fix the control panel to the wall with the provided screws (fig. 17);
10. Electrical connections:
• For models HSCU2GC and HSCU2C:
make the electrical connections and insert the backup battery with refer-
ence to chapter 5 .
• For models HSCU2W and HSCU2GW:
connect the battery (battery pack) as shown in fig. 18;
11. Close the container (fig. 19);
12. Now install the various devices and program the control panel .
8
9