Preventive Maintenance; Safety Conditions; Condition Of The Housing; Condition Of Cables And Terminals - Ingeteam INGECON SUN ComBox Manuel D'installation

Preventive maintenance

12. Preventive maintenance
The recommended preventive maintenance tasks must be carried out at least ANNUALLY, except where otherwise
stated.

12.1. Safety conditions

Before opening the unit, you must remove the power.
You must consider the set of conditions listed below as minimum requirements.
An open housing never implies an absence of voltage in the unit, so only qualified personnel may
access the unit, following the safe operation guidelines stipulated in this document.
Ingeteam accepts no liability for any damages caused by improper use of the equipment. Any work
carried out on any equipment which implies a modification of the original electrical arrangements
must be proposed in advance to Ingeteam. These must be studied and approved by Ingeteam.
All the maintenance checks included here must be carried out with the machine stopped, under safe
conditions for handling, including those specified by the client for these types of operation.
When carrying out maintenance work on the unit, you must wear the Personal Protective Equipment
specified in Section "3.2. Personal Protective Equipment (PPE)" of this manual.
After completing the maintenance task, replace the front cover and secure it with the bolts supplied.

12.2. Condition of the housing

You must carry out a visual check of the condition of the housing, confirming the condition of the seals and the
covers. In addition, you must check the condition of the housing for dents or scratches that might degrade the
housing or cause it to lose its protection classification. If you notice these types of defect, the affected parts must
be repaired or replaced.
Check that there is no moisture inside the housing. If moisture exists, you must dry it before making electrical
connections.

12.3. Condition of cables and terminals

• Check the correct path of the cables so they do not come into contact with live parts.
• Visually check that the connections are properly adjusted.
AAX2015IQM01_ - Installation and usage manual
Ingeteam
DE
EN
ES
FR
IT
PT
59