Safety Information - EINHELL BT-SM 2131 Dual Mode D'emploi D'origine

Anleitung_BT_SM_2131_Dual_SPK7:_
GB
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep these
operating instructions in a safe place so that the
information is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and the safety information as
well. We cannot accept any liability for damage or
accidents which arise due to a failure to follow these
instructions and the safety information.

1. Safety information

Please refer to the booklet included in delivery for the
safety information.
CAUTION
Read all the safety regulations and instructions. Any
errors made in following the safety information and
instructions set out below may result in an electric
shock, fire and/or serious injury.
Keep all safety information and instructions in a
safe place for future use.
1.1 Special information about the laser
Important: Laser radiation
Do not look into the beam
Laser class 2
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the
equipment in any other way may result in
hazardous exposure to laser radiation.
Never open the laser module.
When the crosscut saw is not going to be used for
an extended period of time, the batteries should
be removed.
It is prohibited to carry out any modifications to
18
14.10.2010 15:39 Uhr Seite 18
the laser to increase its power.
The manufacturer cannot accept any liability for
damage due to non-observance of the safety
information.
2. Layout
1. Handle
2. ON/OFF switch
3. Release lever
4. Machine head
5. Saw shaft lock
6. Adjustable blade guard
7. Saw blade
8. Clamping device
9. Additional feet
10. Workpiece support
11. Fixed stop rail
12. Table insert
13. Adjustable foot
14. Locking screw
15. Pointer
16. Scale
17. Turntable
18. Fixed saw table
19. Scale
20. Pointer
21. Locking screw
22. Sawdust bag
23. Drag guide
24. Locking screw for drag guide
25. Fastening bolt
26. Locking screw for workpiece support
27. Knurled screw for cutting depth limiter
28. Stop for cutting depth limiter
29. Adjusting screw
30. Adjusting screw
31. Flange bolt
32. Outer flange
33. Button
34. Movable stop rail
35. Laser
36. Swing-out stability bar
37. ON/OFF switch for laser
38. Transport handle