Safety Information; Intended Use - EINHELL BT-UP 470 Mode D'emploi D'origine

Anleitung_BT_UP_470_SPK7:_
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and the safety
information as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety information.

1. Safety Information

Please refer to the booklet included in delivery for the
safety information.
CAUTION
Read all the safety information and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury. Keep all safety regulations
and instructions in a safe place for future use.
2. Layout (Fig. 1-3)
1. ON/OFF switch
2. Safety lever
3. Handle
4. Knurled handle
5. Workpiece clamping device
6. Guide rails
7. Plastic feet
8. Locking screw for angle stop
9. Saw blade position indicator
10. Angle stop
11. Push stick in holder
12. Machine table
13. Table insert
14. Saw blade
15. Extractor socket
16. Saw blade guard
17. Saw blade cover
18. Hexagon wrench
19. Spindle lock
20. Saw blade screw
21. Washer
22. Outer flange
23. Parallel stop
24. Locking screw for parallel stop
25. Dust bag (not illustrated)
10.11.2009 15:48 Uhr Seite 15
3. Items supplied (Fig. 1-4)
Universal Panel Saw
Carbide-tipped saw blade
Angle stop
Push stick
Parallel stop
Tools
Installation material
Plastic feet

4. Intended use

The universal panel saw is designed for the slitting
and cross-cutting (only with the cross stop) of timbers
and panels, commensurate with the equipment's size.
The equipment is not to be used for cutting any type
of round wood.
The equipment is to be used only for its
prescribed purpose.
Any other use is deemed to be a case of misuse. The
user/operator and not the manufacturer will be held
liable for damage and/or injuries of any kind that
result from such misuse.
The equipment is to be operated only with suitable
saw blades (saw blades made of HM or CV) It is
prohibited to use any type of HSS saw blade and
cutting-off wheel.
To use the equipment properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the equipment have
to be acquainted with this manual and must be
informed about the equipment's potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of health and
safety at work.
The manufacturer will not be liable for any changes
made to the equipment nor for any damage resulting
from such changes.
Even when the equipment is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the equipment's construction and
design:
Contact with the saw blade in the uncovered saw
zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of workpieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the
sawblade.
GB
15