lifter RX 10 Manuel D'utilisation Et D'entretien page 12

Structure (7.9)
Drive (8.4)
Steering bar (9.10+X60)
Brakes (10.7)
Hydraulic circuit (11.9)
Electrical circuit (12.7)
In no case may the plates be removed or made illegible.
IMPORTANT: IT IS FORBIDDEN TO EXCEED THE LOAD SHOWN ON THE C TYPE PLATE FIXED TO THE MACHINE AT THE MOMENT OF
SALE AND SHOWN HEREUNDER: This diagram illustrates the relationship between the maximum load that can be lifted and the relative
maximum heights from the ground during loading and unloading operations of a pallet from a shelf. The fork diagram shown to the side
indicates the center of gravity of the load that, however, must be distributed as uniformly as possible along the whole length of the fork!!
TRANSPORT AND SET UP
Transport (14.1)
Set up (15.1)
BATTERY (16.6)
Charging the battery
Never completely uncharge the battery and avoid partial charging; Allow the battery charger to signal completion of charging.
WARNING: If the batteries are allowed to run down too much their life will be shortened.
Substituting the battery (17.4)
and connect it correctly.
( the battery must always be of the same type that it replaces) IMPORTANT: USE THE SULPHURIC ACID WITH CARE, IT IS TOXIC AND CORROSIVE; IF SKIN OR
CLOTHES COME INTO CONTACT WITH THIS ACID WASH WITH ABUNDANT SOAP AND WATER. IN CASE OF ACCIDENTS CONSULT A DOCTOR!!! After replacing
the battery, consign the used one to the nearest petrol station.
Battery check
USE (18.2+X61)
Safety Regulations
10