Troubleshooting - Ryobi RYi2322E Manuel D'utilisation

PROBLEM
Engine will not start.
Engine hard to start.
Engine lacks power.
Electric start feature not working
AC receptacle does not work.
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance section.
It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing to perform the
required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause irreversible engine damage
and/or void your warranty.

TROUBLESHOOTING

POSSIBLE CAUSE
EASY START dial is in OFF/STORAGE
position.
No fuel.
Stale gasoline or water in gasoline.
Lubricant level is low.
EASY START dial is in ON position and
the GENCONTROL display is in sleep
™
mode
Spark plug faulty, fouled, or improperly
gapped.
Engine stored without treating or draining
gasoline, or refueled with bad gasoline.
Dirty fuel filter.
CO sensor LED is flashing red, indicating
a CO hazard.
CO sensor LED is flashing yellow and/
or making an audible chirp, indicating a
sensor fault.
Auto-Choke feature not working properly.
Water in gasoline.
Weak spark at spark plug.
Engine stored without treating or draining
gasoline, or refueled with bad gasoline.
Dirty air filter.
Auto-Choke feature not working properly.
Battery pack is not installed
Battery pack is not charged
LCD display is not on
Item plugged in is defective.
Generator is overloaded.
22 — English
SOLUTION
Move EASY START dial to ON position.
Fill fuel tank.
Drain entire system and refill with fresh
fuel.
Engine is equipped with Low Oil Shutoff.
If engine lubricant level is low, it must be
filled before unit will start. Check engine
lubricant level and fill, if necessary.
Press the Bluetooth
pairing button to
®
reset the GENCONTROL
™
Replace spark plug.
Drain fuel and carburetor. Refuel with
fresh gasoline.
Contact a qualified service center.
Leave area immediately and relocate
to an open outdoor area. Ventilate area
thoroughly before occupying again. En-
sure the generator is located in an open,
outdoor area at least 20 feet away from
all doors, windows, and occupied spaces,
and point exhaust away from occupied
structures.
The CO sensor needs to be repaired or
replaced. Contact customer service or
a qualified service center for assistance.
Manually open choke and start engine.
Drain entire system and refill with fresh
fuel.
Replace spark plug or contact a
qualified service center.
Drain fuel and carburetor. Refuel with fresh
gasoline. If problem continues, contact a
qualified service center.
Clean or replace as needed.
Manually close the choke.
Install battery pack
Charge the battery pack
Press Bluetooth pairing button to turn
®
the LCD display on.
Try a different item.
Remove loads and press the reset button.