Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PROBLEM
Engine will not start.
Engine hard to start.
Engine lacks power.
DC receptacle does not work.
AC receptacle does not work.
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance
section. It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing
to perform the required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause
irreversible engine damage and/or void your warranty.
All manuals and user guides at all-guides.com

TROUBLESHOOTING

POSSIBLE CAUSE
Engine/choke lever is in run position.
No fuel.
Stale gasoline or water in gasoline.
Lubricant level is low.
Spark plug faulty, fouled, or improperly
gapped.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Dirty fuel filter.
Water in gasoline.
Weak spark at spark plug.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Dirty air filter.
Circuit protector engaged.
Item plugged in is defective.
Item plugged in is defective.
Generator is overloaded.
19 — English
SOLUTION
Move engine/choke lever to start position.
Fill fuel tank.
Drain entire system and refill with fresh
fuel.
Check engine lubricant level and fill, if
necessary.
Replace spark plug.
Drain fuel and carburetor. Refuel with
fresh gasoline.
Contact a qualified service center.
Drain entire system and refill with fresh
fuel.
Replace spark plug or contact a
qualified service center.
Drain fuel and carburetor. Refuel with
fresh gasoline. If problem continues,
contact a qualified service center.
Clean or replace as needed.
Remove any load from the generator.
Turn the auto idle switch to off, then
depress the DC circuit breaker.
Try a different item.
Try a different item.
Remove loads and press the reset
button.

Publicité

Table des Matières
loading

Table des Matières