Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Undo and remove the lock screw and washer. (Fig. 3). Clean and recoat the
CF Allroad Pro Carbon's two leaf springs with carbon paste (see details on page
46). Coat the supplied Anti-Slip Shim with a little carbon paste on the unprinted
side. (Fig. 4). Use the additional carbon paste as supplied with the one Anti-Slip
Shim as required.
Fig. 3: Remove the lock screw and
washer.
60
Montage-Paste
Assembly Paste
Für Carbon- und Aluminiumkomponenten
For carbon and aluminum components
Fig. 4: Use carbon paste on the
indicated surfaces.
Fit the anti-slip shim unprinted side down onto the inner side of the rear leaf
spring (the one marked BACK). The marking on the anti-slip shim should be level
with the noted saddle height 'b' so that the shim is about in the middle of the
binder bolt clamping area when the post is placed back in the bike at the correct
height. (Fig. 5). Fit the washer and lock screw and lightly tighten the lock screw
2 turns (Fig. 6).
b
Fig. 5: Place the Anti-Slip shim on the
inside of the rear leaf spring as
indicated.
b
b
Fig. 6: Fit the washer and lock screw
and fasten loosely.
EN
2 x
61
Publicité
Chapitres
Table des Matières
