Before Installation Of The Seatpost; Adjusting The Saddle Position - Ergon CF Allroad Pro Carbon Instructions D'installation Et D'utilisation

EN
Before installation of the seat post
Remove the lock screw at the base of the seat post and place this, together with
the washer on one side. The two leaf springs can now move freely around the
pivots at the saddle clamp end of the post. Open the two leaf springs to form a
'v' shape. Coat the areas shown below with the included carbon assembly paste
thinly and evenly (between the leaf springs, and front and back) (Fig. 1). Replace
the lock screw and washer and tighten the screw with two turns – the leaf
springs should be able to slide against each other (Fig. 2).
Montage-Paste
Assembly Paste
Für Carbon- und Aluminiumkomponenten
For carbon and aluminum components
Fig. 1: Remove the lock screw and
washer. Apply Ergon or Dynamic
carbon paste.
46
2 x
Fig. 2: Replace the lock screw and
washer. Tighten with 2 turns.

Adjusting the saddle position

Guide the seat post into the frame to the seat height that you had with your old
post. Check first to insure that the entire seat tube is free of sharp edges and
burrs. Carefully remove any burrs that are found in the clamping area by using
fine-grain emery paper (Fig. 1). Furthermore, the seat tube of the frame must be
clean and free of lubricants. Clean the seat tube with an absorbent (cotton) rag.
Use alcohol to remove any stubborn residues of grease (Fig. 2). Never use
aggressive cleaners such as acetone.
While cleaning, look for cracks and scratches, as well as bent or
discolored material. If in doubt, contact your Ergon dealer. Have any
damaged parts replaced at once.
Fig. 1: Remove any burrs from the seat
tube using fine grit sandpaper.
%
ALC.
Fig. 2: Remove any grease and oil from
the seat tube using a degreaser.
EN
47