Ergon CF Allroad Pro Carbon Instructions D'installation Et D'utilisation page 28

EN
Further adjustment of the horizontal position of the saddle by flipping Flip
Head
In order to change the horizontal adjustment range using the Flip Head
(Fig. 3/4), loosen and remove the clamping screws, the external clamp, the
saddle and the internal clamp, and re-install all four parts to the opposite side of
the seatpost (Fig. 1/2). Fit the clamp and the saddle as described on pages
44–45. Now adjust the fore/aft (horizontal) position by sliding the saddle as you
prefer. Tighten the fixing screws to 4–5 Nm.
Ensure that the marking on the seat post (height scale) always points
to the rear (from the point of view of the direction of motion) when it is
installed. The seat post itself may not be rotated by 180°.
A B
Front
Back
Fig. 1: Remove the outer and inner
clamps of the Flip Head in pairs.
54
B A
Front
Back
Fig. 2: Fit the clamps to the opposite
side of the seatpost.
-
Back Front
Fig. 3: This position allows the saddle
to be moved further back (Fig. 1).
+
Back Front
Fig. 4: This position allows the saddle
to be moved more foreword (Fig. 2).
EN
55