Setting The Node Address - Lenze E82ZAFPC201 Instructions De Montage

7 Commissioning

Setting the node address

Setting the node address
The bus device address can be set with the DIP switches S1 ... S7 (2) or via code C1509.
)
Note!
The bus device addresses of networked controllers must differ from each
ƒ
other.
If the DIP switches S1 ... S7 are in the OFF position, the code setting for the
ƒ
bus device address is active.
Switch off the voltage supply of the function module and the controller,
ƒ
and then switch it on again to activate changed settings.
Valid address range
Input via
l
Operating module or
»GDC«
l
DIP switches
Setting via code
ƒ DIP switches S1 ... S7 = OFF (Lenze setting)
ƒ Set the bus device address via C1509.
70
Valid address range
3 ... 126
3 ... 125
l
Notes
−
If the addresses 0, 1, 2, 126 or 127 are set,
the settings from code C1509 become active.
EDK82ZAFPC−201 DE/EN/FR 7.0