Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The stove is clogged
early in the brazier with
burning irregular, door
glass gets dirty, the
flame is long, eddish
and weak
Smell of smoke in the
environment. Turning
off the stove.
In the automatic posi-
tion the stove always
runs at full power
The engine smoke ex-
traction does not work
93
1. Flue with presence of stretches
too long or clogged
2. Too pellet
3. Excessive pellet or ash deposits
in the brazier
4. The brazier is not found in its
slot
5. Wind contrary to the exhaust
flo
6. Insufficient combustion ai
7. You changed the type of pellets
used
8. Smoke extractor motor broken
9. Door closed incorrectly
1. Poor combustion
2. Malfunction of fan fumes
3. Installation of the flue pe -
formed incorrectly
4. Clogged chimney
1. Room thermostat set to maxi-
mum
2. Significant temperatu e sensor
failure
3. Control panel defective or
broken
1. The stove has no voltage
2. The motor is broken
3. The board is defective
4. The control panel has failed
1. Perform periodic cleaning. See paragraph stove in-
stallation in the user manual. Check chimney cleaning
2. Decrease in the parameters the charge level of the
pellets
3. Clean the brazier after waiting for the total shut-
down of the stove. If you repeat contact
service@gimeg.nl
4. Check that the hole in the brazier matches the glow
plug
5. Check the chimney cap windproof and / or possibly
install it
6. Check the correct position of the brazier, its cleanli-
ness and check that the air intake in both free environ-
ment, verify the status of the door seal, increase the
level in the parameter relative to the speed of the fan
exhaust fumes. Contact service@gimeg.nl.
7. Check the quality of the pellets. Contact
service@gimeg.nl.
8. Increase the level in the parameters relating to the
speed of the fan exhaust fumes. Check and eventu-
ally replace motor
9. Check that the glass is sealed and the seal guaran-
tees tightness
1. Contact service@gimeg.nl
2. Contact service@gimeg.nl
3. Contact service@gimeg.nl
4. Contact service@gimeg.nl
1. Reset the thermostat temperature
2. Check the operation of the sensor and replace if
necessary
3. Check the control panel and replace if necessary
1. Check the supply voltage and the protection fuse.
2. Check the motor and capacitor and replace if neces-
sary.
3. Replace the circuit board.
4. Replace the control panel.
Publicité
Table des Matières
