livin flame Stavanger 6 Mode D'emploi Et D'installation page 87

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fig.7
Fig. 8
Fig. 6.1
Fig. 6.2
Fig. 9
Fig. 10
Cleaning the clearing system
Until a reasonable experience is acquired regarding the operating conditions, it is advisable to perform
this maintenance on at least a monthly basis.
• Remove the electrical feed cable;
• Remove the cap from the T-joint and proceed with the cleaning of the ducts. If necessary, at least for
the first few times, call in qualified personne
• Carefully clean the smoke discharge system: for this, contact a professional chimney sweep;
• Once a year clean the dust, cobwebs, etc. from the zone behind the internal covering panels, paying
particular attention to the fans.
Cleaning the fans
The stove is furnished with fans (environmental and smoke) positioned at the rear and below the
stove. Eventual deposits of dust or ash on the blades of the fan can cause an imbalance in the fans
leading to noisy performance.
It is, therefore, necessary to clean the fans at least once a year.
Since said operation requires dismantling several parts of the stove, have the fans cleaned only
by our technicians.
87

Publicité

Table des Matières
loading

Produits Connexes pour livin flame Stavanger 6

Ce manuel est également adapté pour:

Stavanger 8Tromvik 6Tromvik 8Ulvik 8Ulvik 10Liland 8

Table des Matières