livin flame Stavanger 6 Mode D'emploi Et D'installation page 77

Stove switching off
To switch off the stove, press the key
on the display. After the stove has been switched off, the fan continues working for a set time in order
to grant a fast smokes exhaust from the combustion chamber.
If you have a model with remote control, you just need to switch the remote control off keeping the key
pressed for 2 seconds and confirming the selection pressing the key SEND.
If you try to switch on the stove during this phase, the display will show "W AI TI NG
C O OLIN G " (that means wait for cooling) in order to inform you a switching off phase is
running. Wait until the cooling phase is completely off and the display shows "OF F" before staring a
new light up.
REMARKS:
• Do not continuously turn the stove on and off as this could provoke sparks that could shorten the life
of the electrical components.
• Do not touch the stove with wet hands: the stove has electrical components that could produce sparks
if handled incorrectly. Only authorized technicians can resolve possible problems.
• Do not remove any screws from the fi e chamber without first lubricating them well
• Never open the glass door of the pellet stove while the stove is in operation.
• Be sure that the brazier basket is positioned correctly.
• The flue system must be suitable for inspecion. If it cannot be removed, it must have some holes for
inspection and cleaning.
77
on the control board until you read "CLE A NI NG FIN AL"