Stove Start Up - livin flame Stavanger 6 Mode D'emploi Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Stove start up

Remove any components which might burn from the firebox and from the glass
(various instructions and adhesive labels).
Charge pellet
Fuel is loaded from the upper part of the thermostove by opening a door. Pour the pellets in the hopper.
This is easier if performed in two steps:
• Pour half of the contents of the bag into the hopper and wait for the fuel to settle on the bottom.
• Then pour in the rest.
Never remove the protection grille in the hopper. When filling, do not let the
sack of pellets touch any hot surfaces.
The brazier should be cleaned before each starting.
First lighting of the stove
• Before switching on, make sure that the grate is clean and empty of any pellet residues from previous
combustions. Otherwise make sure you empty and clean it
• Fill the container 3/4 full with the pellets recommended by the manufacturer
• Connect the stove to an electrical outlet with the cable that has been supplied
• Press the lighting switch located on the back part of the stove
• The upper display will read "OF F"
• Press the button
will start and the display will read "S TART"; The led resistance is switched on
• After 1 minute the display will read "LOAD
lighting the resistor
• Once the appropriate temperature has been reached the display will read "FLA M E LI G H T ":
this means that the stove has begun the last phase in lighting, at the end of which the stove will be
completely operational; The led resistence is switched off
• After some minutes the display will show the words "W O RK" alternating room temperature and
current working power. The stove is now completely on
• When the stove reaches the set temperature, the display will show "MODULATION ".
Before lighting a small amount of smoke may fill the combustion chamber.
We highly recommend to turn to our Authorized Service Centre for the
installation and the first ignition of the device as it not only carries out
the installation perfectly but also verifies the regular operation of it.
During the first lighting the environment should be well ventilated since during
the first hours of operation unpleasant odours could develop due to the physical
stabilizing of the paint and from the grease in the tube bundle.
for 2 seconds. After a few moments the smoke extractor and the lighting resistor
, the stove will load the pellets and continue
76

Publicité

Table des Matières
loading

Produits Connexes pour livin flame Stavanger 6

Ce manuel est également adapté pour:

Stavanger 8Tromvik 6Tromvik 8Ulvik 8Ulvik 10Liland 8

Table des Matières