livin flame Stavanger 6 Mode D'emploi Et D'installation page 85

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cleaning the glass
The glass is a self cleaning type, therefore, while the stove is working, a veil of air is blown across its
surface to remove ash and dirt; nevertheless over a period of several hours, a greyish patina tends to
form which should be cleaned when the stove is next shut down. How dirty the glass becomes also
depends on the quality and quantity of pellets used.
Cleaning the glass should be done when the stove is cold with products recommended and tested by
our company. When performing this operation, always check that the grey seal around the glass is in
a good state; failure to check the efficiency of this gasket can comp omise the function of the stove.
Poor quality pellets can, in any case, cause the glass to become dirty.
If the glass is broken, do not attempt to light the stove.
Cleaning the surfaces
To clean the surfaces, use a rag dampened with water or with water and a neutral detergent.
The use of aggressive detergents or thinners can damage the surfaces of the
stove. Before using any detergent it is advisable to try it on a small section out
of sight or contact the Authorized Assistance Centre for information regarding
the product.
Cleaning the metal parts
To clean the metal parts of the stove, use a soft cloth dampened with water. Never clean the metal parts
with alcohol, thinners, petrol, acetone or other degreasing substances. If such substances are used, our
company declines any responsibility.
Eventual variations in the colour of the metal parts can be caused by an incorrect use of the stove.
It is necessary to daily clean the brazier and often clean the ash box. The lack of
cleanliness can prevent the starting of the stove, causing damages to the stove
itself and to the environment (possible emission of unbrunt material and soot).
Do not re-use the pellet possibly remained in the brazier due to no starting-up.
CLEANING BY THE TECHNICAL
Check every year
Clean the combustion chamber
Remove the brazier and clean it of any residue.
(photo 1)
85
1

Publicité

Table des Matières
loading

Produits Connexes pour livin flame Stavanger 6

Ce manuel est également adapté pour:

Stavanger 8Tromvik 6Tromvik 8Ulvik 8Ulvik 10Liland 8

Table des Matières