Installation - ZANKER KBA19001SK Mode D'emploi

Problem
Water flows on the ground.
The temperature in the appli-
ance is too low.
The temperature in the appli-
ance is too high.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
Remove the screw from
the lamp cover.
Remove the lamp cover
(refer to the illustration).
Replace the used lamp
with a new lamp of the
same power and specifi-
cally designed for house-
hold appliances (the
maximum power is
shown on the lamp cov-
er).
Install the lamp cover.
Tighten the screw to the
lamp cover.
Connect the plug to the
mains socket.
Open the door. Make
sure that the light comes
on.

Installation

Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Possible cause
Products prevent that water flows in-
to the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
Make sure that products do not touch
the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installa-
tion".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Solution
15