Installation - ZANKER KBT23001SB Notice D'utilisation

The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.

Installation

Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the rating plate correspond to your
domestic power supply.
The appliance must be earthed. The power supply ca-
ble plug is provided with a contact for this purpose. If
the domestic power supply socket is not earthed, con-
nect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electri-
cian.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Door reversibility
The door of the appliance opens to the right. If you
want to open the door to the left, do these steps before
you install the appliance:
22
1
Loosen the upper pin
and remove the spacer.
2
Remove the upper
pin and the upper door.
4
Remove the lower
door.
5
Loosen the lower pin.
3
Loosen the middle
hinge.
On the opposite side:
1
Install the lower pin.
2
Install the lower door.
3
Tighten the middle
hinge.
4
Install the upper door.
5
Tighten the spacer
and the upper pin.